©Copyright 2009 IonWays, LLC VS.1
Page 6
Mounting the Tank Ball Valve
Note: With the tank empty, use the valve on the tank to check the air pressure. Set it at 11-13 psi.
1.) Unplug the plastic cap on the top of the tank.
2.) Wrap the thread 3 times with plumbers (Teflon) tape only.
3.) Connect the ball valve to the thread. Make sure it is tight but not over-tight.
4.) Connect the yellow tubing to the tank ball valve.
5.) Turn the tank ball valve off.
Mounting the Drain Clamp
The drain clamp (VV-DSP014/3) will fit most standard drain pipe 1-1/4”. It should be installed above the trap and
on the vertical tailpiece.
1.) Position the drain saddle in desired location, mark spot through thread outlet, and remove saddle.
2.) Drill ¼” (6.3mm) hole into the drain pipe above the water line of trap.
3.) Align the hole drilled in the drain pipe with the drain saddle using a drill bit or other narrow straight object
and tighten clamp.
4.) Make sure to align drain saddle to drilled hole. Attach drain saddle to drain pipe and tighten the two
screws evenly.
5.) Connect black tubing to drain clamp.