Ethernet
Enter into
“
Comm.
”
→
“
Ethernet
”
.
Serial Comm
PC Connection
To improve the security of attendance data, connection password needs to be set here. Enter into
Comm
.
→
“
PC Connection
”
.
1.
IP Address:
Modify it if necessary. It cannot be
same with PC.
2.
Subnet Mask:
Modify it if necessary.
3.
Gateway:
It is necessary to set an address if the
device and PC are in different network segment.
Modify it if necessary.
4.
DNS:
Set the address of your DNS server.
5.
TCP COMM Port:
Set the TCP communication
port.
6.
DHCP:
Dynamic Host Configuration Protocol,
which is used to allocate dynamic IP addresses to
clients by a server.
7.
Display in Status Bar:
Whether to display
network status icons in the status bar.
1.
Serial port:
When serial port (RS232/RS485)
is used for communication of device and PC,
this setting need to be checked:
2.
Baudrate:
Used for communication with PC.
RS232 is recommended for high speed.
Note:
There are 5 baudrate types available for
RS232: 9600, 19200, 38400, 57600 and 115200;
“9600” is not applicable to RS485. Reboot the
device to make the change active.
1.
Comm Key:
Set 1-6 digits connection
password, the password must be input when
PC software is to connect device to read
data.
2.
Device ID:
The ID is in the range of 1-254. If
RS232 or RS485 is enabled, this ID needs to
be input in the software communication
interface.
