Ioline FJ Printer, Руководство по обслуживанию

Страница: 83 / 116

83
Chapter 4: Repair Procedures
Photo 13 Photo 4
8. Remove keypad from the studs ( Figure 47 , photo 6).
9. Install the new keypad on the studs and tighten the nuts. Do
Not over tighten. ( Figure 47 , photo 6).
10. Install the Y-axis transmission. (Follow Y-transmission proce-
dure replacement in reverse).
11. Connect the keypad resistor to the hole in the keypad Do Not
over tighten. ( Figure 47 , photos 3 & 4 & 5).
12. Rotate the machine to access the main logic board.
13. Loop the new keypad cable through the hole in the end plate
and plug it into the new keypad cable for the main logic board.
Take caution to plug the connector in properly. A missed row
of pins will damage the main logic board and keypad. ( Figure
47 , photos 2 & 1) Note: Pin #1 is marked with a sticker on the
cable. Look on the main logic board for pin #1 and match pin to
socket before plugging in the cable).
14. Install the bottom cover, as described earlier in this chapter.
15. Rotate the machine back to normal operating position and re-
install screws that hold machine to stand legs.
16. Replace the right side cover.
17. Test the plotter.
18. If problems arise, contact Ioline Tech Support.
Photo 5
Photo 6
Nuts
Resistor
Hole for resistor