Ioline FJ Printer, Руководство по обслуживанию

Страница: 45 / 116

45
Chapter 3: Troubleshooting & Testing
Gap between each scan, broken or dotted lines or sections of plot are
missing.
Cause:
1. Frame gap setting is incorrect.
2. Ink cartridge is out of ink, dirty
or the print head is plugged.
3. Ink cartridge is damaged.
4. Ink cartridge bay pins are dirty.
5. Ribbon cable is loose or broken.
6. Service Station refuses to cap
cartridges (FJ Printer only).
7. Logic board failure.
Solution:
1. Use the Control Center to
adjust frame gap as shown in the
Routine Maintenance chapter
of the FJ Printer User Guide .
2. Check ink level indicator.
Replace cartridge if indicator is
black. If cartridge is not empty,
see
Cartridge Maintenance
and Handling under the Rou-
tine Maintenance chapter in
the FJ Printer User Guide .
3. Replace cartridge.
4. Contact Ioline customer service.
5. Tighten or replace the ribbon
cable following instructions
under the
Carriage Procedures
section later in this chapter.
6. Contact Ioline customer service.
7. Contact Ioline customer service.
After plot is sent, machine does not move.
Cause:
1. Plotter is off or unplugged.
2. Wrong baud rate or baud rate
does not match on plotter or
computer.
3. Wrong settings in the software.
4. Data cable is bad.
5. Wrong port being used.
6. Bad fi le.
7. Communication chip on plotter
failed.
Solution:
1. Plug machine in and turn on.
2. Refer to the Serial Communica-
tion section earlier in this chapter.
3. Check the frame size and other
settings in the software.
4. Replace data cable.
5. In the Control Center , verify
that the assigned port matches
the physical port.
6. Check or recreate the plot fi le.
7. Contact Ioline customer service.
During power-up, carriage doesn’t move or moves quickly to the left
or right, then stops.
Cause:
1. Motor failure.
Solution:
1. Contact Ioline customer service.