27
2.3.14 Call chaser manually:
Make sure that manual mode is activated. The LED / MANUAL / must light up.
1. Use the / CHASE 1 to 6 / buttons to select the desired sequence.
2. Press the / TAP / DISPLY / button to display individual / STEP / (program steps).
3. Press
the / BANK ▲ / or / BANK ▼ / button to move from one step to the next in the sequence.
2.3.15 Play chaser automatically:
In automatic mode, the scenes stored in a memory bank are played back in a time-controlled loop.
1. Press the / AUTO / DEL / button to switch to / AUTO / operation.
2. Use the / CHASE 1 to 6 / buttons to select the desired sequence.
3. Now you can set the running speed with the / SPEED / fader and the fade time with the / FADE TIME / fader.
When setting, the values are shown in the display in seconds.
You can also set the expiry interval with the / TAP / DISPLAY / button. The interval between two key presses
corresponds to the interval sequence. The largest possible interval is 10 minutes.
2.3.16 Play scenes controlled by music:
In music-controlled mode, scenes (steps) stored in a memory bank are synchronized with music pulses at the /
AUDIO / socket or the individual steps run in time with the music recorded via the internal microphone if the socket
is not connected.
1. Press the / MUSIC / BANK COPY / button to switch to / MUSIC / operation.
2. Use the / CHASE 1 to 6 / buttons to select the desired chase.
3. Use the / FADE TIME / fader to set the crossfade speed. When setting, the values are shown in the display in
seconds.
2.4 Override function:
With the override button, you can remove individual devices from a running program (chase) and control them
manually. To do this, press the / SCANNERS / selection button and then the / OVERRIDE / button while the
control LED is on. With the first fader movement you remove the headlight from the program and you can control
all functions manually. Press again to switch off the override function.
2.5 Blackout function (dark switching):
With the blackout function, the DMX output can be switched completely dark. The fade-out and sequences are not
stopped by the blackout function, they continue to run “in the dark”.
2.6 MIDI operation:
The device can be controlled via MIDI e.g. B. control with a MIDI keyboard or sequencer software.
For MIDI control, the device must be set to the MIDI channel via which it is to be controlled:
1. Hold down the / MIDI / REC / button until the display shows "MIDI 01" on the top line.
2. Use the / BANK ▲ / and / BANK ▼ / buttons to select the MIDI channel
3. Press the / MIDI / REC / button for two seconds to save the setting and exit.
