26
The previously saved scenes can be combined and saved in any order to form a chase sequence. There are 6
memory locations available for this. A sequence of up to 160 scenes can be programmed on each. The chase
sequences can run manually, automatically, or music-controlled.
2.3.9 Programming a chaser:
1. Press and hold the / PROGRAM / button until the control LED flashes.
2. Use the / CHASE 1-6 / buttons to select the desired memory location.
3. Call up the scene with the corresponding key (if necessary, select the memory bank beforehand using the /
BANK ▲ / and / BANK ▼ / keys).
4. Press the / MIDI / REC / button to save the scene. To confirm the saving process, all LEDs of the controller flash
three times.
5. Repeat steps 3 and 4 to set the next scenes.
6. Press and hold the / PROGRAM / button to exit programming mode.
2.3.10 To delete a chaser:
1. Press and hold the / PROGRAM / button until the control LED flashes.
2. Use one of the / CHASE 1-6 / buttons to select the sequence to be deleted.
3. Hold down the / AUTO / DEL / button and simultaneously press the / CHASE / button of the chase to be deleted.
To confirm the process, all LEDs on the controller flash three times.
2.3.11 Delete all chasers:
Note:
If you delete all chasers, they will be permanently lost and cannot be called up again. The individual scenes
and programs (“banks”) remain unaffected.
1. Turn off the device.
2. Simultaneously hold down the / AUTO / DEL /
and / BANK ▼ / buttons and switch on the device.
After approx. 2 seconds, all LEDs of the controller light up briefly. The deletion has taken place.
2.3.12
Copy a complete “bank” into a chaser:
Would you like to go a little faster? Then you will now lea
rn how an entire “bank” consisting of 8 finished scenes
can be copied into a chaser.
1. Press and hold the / PROGRAM / button until the control LED flashes
2. Use the / CHASE 1-6 / buttons to select the desired memory location.
3. Use the / BANK ▲ / and / BANK ▼ / buttons to select the memory bank (1-20) to be inserted.
4. Then press the / MUSIC / BANK COPY / and / MIDI / REC / buttons simultaneously. To confirm the saving
process, all LEDs of the controller flash three times.
This way you can quickly and easily add 8 scenes to a chaser.
2.3.13 Playing a chaser:
A chaser can run manually, time-controlled or music-controlled. Manual mode is always activated as the basic
setting. The LEDs MANUAL, AUTO and MUSIC indicate the current setting.
