for a full five minutes so that the Computer
Collar receiver’s microprocessor has enough
time to recycle after the old battery has been
removed.
To install a new battery, line up the two lugs on
the bottom of the Power Cap with the two grooves in
the sides of the battery chamber. Gently put the Power
Cap into the chamber while turning it clockwise with
your fingers. Finally, use a small, thin coin in the slot
on the top of the battery to turn the battery clockwise
until the slot on the
top of the battery is
lined up with the
two small raised
tabs on the bot-
tom of the receiver.
When the new
Power Cap is in, wait 10 seconds before taking the
receiver into the signal field to give the receiver time
to recycle.
Failure to follow these directions exactly, may
result in the Computer Collar receiver not activating
properly. To maintain optimum performance, we rec-
ommend that you periodically test the battery.
Warning: The Power Cap battery case
is made of soft, protective material.
The use of unnecessary force may damage the
case and render the battery inoperable.
Warning: NEVER open a Power Cap,
dispose of it in fire, recharge it, heat it
above 212˚F(100˚C), or expose its contents to
water. Doing so can cause leakage or explosion
and may lead to personal injury.
Power Cap Battery Tester
We strongly recommend that each customer
obtain a Power Cap battery tester. At least once a
month, check the receiver battery with the Power Cap
battery tester to be sure that your pet will stay out of
areas that it is supposed to, and remain safely within
your Invisible Fence system.
The Power Cap battery tester measures the inter-
nal resistance of a Power Cap battery and shows how
much life is left in the battery.
To test a receiver battery with the Power Cap bat-
tery tester, remove the battery from the receiver and
Computer Collar
®
Receivers continued
12
put it into the Power Cap battery tester the same way
that you would put it into a receiver. If the battery is
good, the green and red LEDs on the tester will both
light. If neither LED
on the tester lights,
or just the red LED
lights dimly,
the
battery needs to be
replaced.
