Invicta Thicknesser DGI-63D, Руководство оператора

Страница: 7 / 32

Thicknesser Model DGI-63D
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating
from all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use
acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good
quality household floor paste wax.
UNLOADING AND POSITIONING MACHINE
This machine should be unloaded using a crane and slings around
and under the table on both sides, as shown in Figure 2. Lift the
machine slowly, making sure it is well balanced, and lower it
carefully.
06
Using rollers or a similar hauling device, push the machine to the
desired working site. Once the machine is in position it should be
leveled and positioned on hard rubber pads placed underneath the
four corners.
Remove protective coating from the table, bed rolls, feed rolls and
cutterhead. This coating may be removed with a stiff brush and/or
soft cloth moistened with kerosene (do not use acetone, gasoline or
lacquer thinner for this purpose).
WARNING CARE MUST BE TAKEN WHEN CLEANING THE
CUTTERHEAD AS THE KNIVES ARE IN THE
CUTTERHEAD AND THESE KNIVES ARE VERY SHARP.
Fig. 2
After cleaning table, cover table surface with a good quality paste
wax.
10
4
8
2
10
2 8
5
6
9 3
11
3
9
5
11
4
7 1
12
1
7
6
12
230 VOLT 460 VOLT
MOTOR CONNECTIONS
ELECTRICAL CONNECTIONS
Before connecting your machine to an electrical power system, make sure
the motor rating agrees with the electrical system it is to be connected to.
The 24" Planer is shipped wired for 230 volts, three phase operation.
If you desire to operate your planer at 460 volts, three phase operation,
refer to the Electrical Instruction Manual supplied with your planer for
detailed instructions on Changing Voftage of LVC Motor Starters. Three
STEPS must be followed when changing line voltage. These steps are as
follows:
1. Change leads in the motor junction box for the proper line voltage, as
shown on the motor nameplate. Refer to Fig. 3.
2. Move the transformer primary pigtail to the proper terminal corresponding
to the new input voltage.
Fig. 3
3. Change the heater elements in the overload block for the proper voltage/amperage rating shown on the motor
nameplate.
These three steps are clearly explained in the electrical instructions supplied with your planer.