Thicknesser
Model DGI-63D
13
CHECKING AND ADJUSTING
BED ROLL HEIGHT
The height of the bed rolls (A) and (E) Fig. 23A, should
be set between .002" and
.004" above the table
surface,
with the bed rolls at their lowest position. To
check the infeed bed roller height setting, proceed as
follows:
1. DISCONNECT MACHINE FROM POWER SOURCE
2. Turn height adjustment knob (B), counterclockwise
as far as it will go.
3. Place a straight edge (C), across the infeed and
outfeed rollers on the left side of the table as shown.
4. With a feeler guage (D), measure the gap between
the table surface and the straight edge (C) near the
infeed roll (E).
5. If an adjustment to the infeed roller (E), is necessary,
loosen set screw (F) Fig. 23B, located underneath the
left front end of the table.
6. Turn adjustment collar (G) Fig. 23B left or right as
needed to attain proper height adjustment.
7. Tighten set screw (F) Fig. 23B after adjustment is
made.
To check the outfeed roller height setting, proceed
as follows:
1. With a feeler guage (H) Fig. 23C, measure the gap
between the table surface and the straight edge (C)
near the outfeed roller (E).
2. If an adjustment to the outfeed roller is necessary,
loosen jam nut (K) Fig. 230, located on the left side of
machine under the table, and turn collar (L) right or left
as needed until the outfeed roller is adjusted properly.
3. Tighten jam nut (K) Fig. 23D.
Fig. 23A
Fig. 23B
Fig. 23C
D
A
E
C
F
G
C
H
E
L
K
Fig. 23D
