Thicknesser
Model DGI-63D
Fig. 21
Fig. 22
A
B
A
C
A
B
B
A
12
LEVELING THE TABLE
The table must be parallel to the cutterhead knives. To
check and adjust, proceed as follows:
1. WARNING DISCONNECT MACHINE FROM
POWER SOURCE
2. Remove the four screws that attach the top cover to
the planer and carefully remove the top cover.
3. Place a straight edge (A) Fig. 21, on the ground
surfaces (B) of the planer, as shown.
4. Place the guage block (C) Fig. 21, on the table
directly underneath the straight edge at one side, as
shown, Raise the table until the guage block just
touches the straight edge. Do not raise or lower the
table any further until the adjustment for leveling the
table is completed.
5. Move the guage block (C) Fig. 21, to the opposite
(left end) of the table and check to see if the table is
the same distance from the straight edge as on the
right side.
6. Place the straight edge (A) on the two ground
surfaces (B) of the outfeed end of the planer as shown
in Fig. 22. Check both ends of the table with guage
block (C) to see if table is level.
7. If the table is low or high at any of the four points
checked with the guage block in Figs. 21 and 22,
locate the post directly underneath the end of the table
that must be adjusted. Then loosen the three screws,
two of which are shown at (A) Fig. 22A, and turn flange
(B) to raise or lower the table at that end.
Fig. 22A
