Thicknesser
Model DGI-63D
Fig. 38
B
C
A
B
A
17
ADJUSTING CHIP DEFLECTOR
1. WARNING DISCONNECT MACHINE FROM
POWER SOURCE
2. Remove the cutterhead guard.
3.
The edge (C) of the chip deflector (A) Fig.
38, should be adjusted so it is a minimum of
.040" and a maximum]
of .080" away from the
cutting circle. Place a feeler gauge between the knife
and the edge of the chip deflector as shown in Fig. 38.
If an adjustment is necessary, loosen three screws (B)
and move chip deflector.
ADJUSTING TABLE HEIGHT SCALE
The table height scale is adjusted at the factory to
indicate the distance from the table to the cutting circle
(depth of cut).
To check and adjust the pointer, proceed as follows:
1. Run a piece of wood part way through the planer
and stop the machine.
2. Measure the thickness of the finished piece. If
necessary, loosen two screws (A) Fig. 39 adjust pointer
(B) and retighten screws (A).
GAUGE BLOCK
A gauge block has been supp
lied with your planer;
however,
if it is ever necessa
ry to make a gauge block
out of
hardwood, follow the instructions shown in Fig.
40.
Fig. 39
Fig. 40
