inventum IKV1781S, Инструкция по эксплуатации

Страница: 23 / 32

troubleshooting
7
If your appliance is not working properly, it may be a minor problem, therefore check the following:
Problem Cause Solution
Appliance is not functioning; light
does not work
- Appliance is not plugged in
- There is a power failure
- The thermostat is set on
●
- Plug the appliance in
- Check the fuse box
- Set the thermostat on setting 1-5
Temperature inside the
refrigerator is too high or too low
Thermostat has been set
incorrectly
Set the thermostat correctly
Air circulation vents are blocked Clean the ventilation openings
Water is running out of the
refrigerator
Drain outlet is blocked Clear the drain outlet with a skewer
Appliance is excessively noisy Has the appliance been installed
correctly?
Check the installation
Are the pipes at the back touch-
ing or vibrating?
Check it and move the appliance forwards
The inside light is not working Lamp is defective Contact the customer service department
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
English •
23
installation instructions
8
Before installation, read the instructions carefully.
• Fit the refrigerator/freezer in stable kitchen units only with sufficient ventilation (figure B and C).
• If necessary, reverse the door according to the instructions.
• Check the installation dimensions according to figure C. The position of the joint between the unit doors must be level with the
position of the joint between the appliance doors.
1 See figure A for the necessary attachment components.
2 Insert the trim flap
1
into the slot and screw by screws
6
(figure D).
3 Pass the power cord through the ventilation shaft and position it so that the appliance could be easily plugged in once it has
been installed (figure B and C).
4 Take out the trim gasket
2
located on the side panel of the appliance and stick it on the reverse side of the door hinges of the
appliance (figure E).
5 Raise the appliance and slide into the kitchen unit. Push the appliance to the reverse side of the door hinges providing that the
trim gasket 2 covers the space between the appliance and the kitchen unit.
6 Allign the front feet with the front surface of the kitchen unit (figure F).
7 Screw the front feet by using screws
5
(figure F).
8 Screw the trim flap
1
to the kitchen unit using screws
5
(figure G).
9 Screw the fixing bracket 11, as leaned to the kitchen unit by using screws
5
. Repeat this for the opposite side (figure H).
10 Screw the guides 3 to the appliance doors with screws 6 . Lean the appliance doors to the unit door as it is opened at the right
angle 90°. Slide the rails
4
into the guides
3
aligning the groove. Screw the rails
4
to the unit doors with screws
5
(figure J).
11 Set 1-2 mm gap on the handle side between the unit itself and the unit doors by adjusting the guides
3
(figure J). That is vital for
the appliances performance.