42
ASSEMBLY AND INSTALLATION
inVENTer
®
iV14R/iV14V ventilation system
•
Installation and operating instructions
Sliding sleeve V-186x186x100
Requirements:
Wall opening
□
210 mm inished.
Controller cable in place.
Ö
Ö
Sliding sleeve V-186x186x100 is itted.
►
Determine the exact wall thickness.
Be sure to add
the thickness of exterior
plaster and insulation (1), masonry (2) and
interior plaster (3).
3
1
2
1 – 2°
►
Fit the sliding sleeve (6) into the
wall sleeve (7).
Make sure that
the ixing elements (4) each
point away from the joint (5).
Make sure that
the ixing elements for the
sliding sleeve (6) are parallel to the controller
cable recess (8).
►
Slide the two elements into each other until the
calculated wall thickness is achieved.
6
7
4
4
5
8
►
Seal the joint (10) between the wall sleeve
and sliding sleeve with watertight duct tape (9)
(available as an option).
10
9