OPERATION ON AVIANT´S CONTROL PANEL
10
Aviant extractor fan | Operating instructions
Set run-on time
After the fan switch-off pulse, the fan continues to run for a
selected period of time, if set.
This run-on is activated when the switch-off pulse is triggered
• through humidity sensor;
• through the light sensor;
• by means of an external sensor.
The run-on time always occurs for all shutdown options.
The selection of only one option, e.g. run-on following an
activated humidity sensor, is not possible.
After the end of an run-on cycle, the fan checks wheth-
er the limit values (determined by the sensors) are still
exceeded. If this is the case, a new run-on cycle begins, at
the end of which the shutdown requirements are checked
again. If the limit values are complied with, the Aviant
switches off automatically.
The run-on time can be set to 15 minutes or 30 minutes on
the control panel. If no run-on time is set, the fan switches
off immediately.
►
Touch the icon to activate the control panel.
►
Touch the icon.
The currently set run-on time is displayed:
15 minutes
30 minutes
3.3 Run-on time and switch-on delay
3.2 Light and Air quality sensor
The light sensor is used to automatically monitor changes
in light. The air quality sensor monitors indoor air quality to
quickly remove unpleasant odours when needed.
►
Touch the icon to activate the control panel.
►
Touch the icon.
The active sensors are shown:
Light sensor
Both active
Air quality sensor
Both inactive
►
Touch the icon again for 2 seconds.
The sensors can be activated/deactivated.
►
Touch the icon repeatedly until the desired sensor
combination is active:
Light sensor
Both active
Air quality sensor
Both inactive
►
Touch the symbol twice to apply the changes.
The air flow volume when activated by the light sensor
corresponds to the air flow volume in run-on function.
i
The air flow volume when activated by the air quality
sensor corresponds to the air flow volume when
activated by the humidity sensor.
i
i
