Part No. 1054916
27
T-3™ and T-4™ Series
After 2000 (FIGURE 3)
1. Loosen the locknut at the front of the
seat.
2. Loosen both spreader bar screws.
3. Loosen both seat angle screws.
4. Adjust the spreader bar to the desired
position.
5. Tighten the seat angle screws, spreader
bar screws and the locknut at the front
of the seat.
REAR SEAT HEIGHT ADJUSTMENT
NOTE: This procedure is for T-3 Elite models with rear seat height adjustment and T-3 Adjustable
models ONLY.
WARNING
The position of the footrest, camber tube, seat height, the tautness of the
back upholstery, as well as the user's condition are directly related to the
chair's stability. Any change to one (1) or any combination of the five (5) may
cause the chair to decrease in stability. Use EXTREME caution when using a
new seating position.
Before 2001 (FIGURE 2)
1. Loosen, but do not remove the front set screws.
2. Remove the set screws at the rear of the seat rails.
WARNING
Ensure that both seat rails are aligned in the correct mounting holes for
proper and even seat alignment. A fall and possible injury could occur.
3. Move the rear of the seat rails up or down into one of the five (5) adjustment positions.
*REAR SEAT TO FLOOR RANGE (IN INCHES)
HOLE
#
1
2
3
4
5
*
HEIGHT
13
14
15
16
17
FIGURE 2 - REAR SEAT HEIGHT ADJUSTMENT - BEFORE 2001
SEAT
5
4
3
2
1
Rear Set Screw
Chair Frame
Seat Rail
FIGURE 3 - REAR SEAT HEIGHT
ADJUSTMENT - AFTER 2000
Spreader Bar
Spreader
Bar Screw
Seat Angle Screw
Locknut
SEAT
HOLE NUMBER
PROCEDURE 4
SEAT
