Invacare RPS 440ee, Инструкция по эксплуатации

Страница: 11 / 36

8
9
All information is subject to change without prior notice. Photographs are for illustration purposes only and may vary from product description.
Invacare ® is a registered trademark and Yes, you can.™ is a trademark of Invacare ® Corporation. 2008 Invacare Asia Pacific
RPS 440ee User's Manual RPS 440ee User's Manual
All information is subject to change without prior notice. Photographs are for illustration purposes only and may vary from product description.
Invacare ® is a registered trademark and Yes, you can.™ is a trademark of Invacare ® Corporation. 2008 Invacare Asia Pacific
Assembly
The RPS400ee is packed partly assembled for
shipping purposes. To assemble your RPS400ee,
remove all contents from box and place unit on
workbench or table. Using 16 mm and 17 mm
spanners remove the two bolts connecting the
mast to the chassis.
Remove mast and boom assembly from base (1).
Position upright and attach mast to base using
the previously removed bolts.
Note: Ensure these bolts are firmly tightened.
Attach the rod ends as shown in (2).
Cut cable tie securing actuator (3), and swing
actuator forward so that it is out of the way.
Swing boom up and over to the front (4) .
Attaching the kneepad receiver
Note: The kneepad is an integral part of the lift and must be
attached so that the lifter can function correctly and safely.
Remove the two hex screws on front of mast
behind the actuator. Align the kneepad receiver
assembly over the screw holes (5). Ensure the
assembly is correctly orientated - the kneepad
release lever should be on top. Replace the
screws. Tighten firmly.
!
When assembling the patient lift, it is important to tighten bolts according to
instruction. Failure to do so may result in damage to the lift or injury to the care-
giver or client.