SECTION 7—FRONT RIGGINGS
Part No 1134839
55
Power Tiger™
FIGURE 7.3
Adjusting Flip-Up Footplate Angle
Adjusting Flip-Up Footplate Perpendicular and/or Inversion/Eversion
NOTE: For this procedure, refer to FIGURE 7.4.
1. Loosen, but DO NOT remove, the two flat screws, washer and locknuts that secure the
footplate to the footplate hinge.
2. Position the articulating footplate to the necessary angle to accommodate the user.
3. Retighten the two flat screws, washers and locknuts.
FIGURE 7.4
Adjusting Flip-Up Footplate Perpendicular and/or Inversion/Eversion
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 7.5 on page 56.
Composite Footplates
1. Remove the mounting screw and coved washer that secures the lower half of the
footrest to the swingaway footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screw, spacer and locknut that secure the heel loop to the
footrest.
4. Slide heel strap over cane of footrest assembly.
5. Replace heel strap/loop.
6. Reverse STEPS 1-4 to reassemble.
NOTE: When securing heel loop to the footrest assembly, tighten mounting screw until the spacer
is secure.
Footrest Support
Articulating Footplate
Side View Of
Footplate and
Footrest
Support
Half Clamp
Nylon Adjustment Screw
Footrest
Support
Footplate
Front View Of
Footplate and
Footrest Support
