SECTION 6—WHEELCHAIR OPERATION
Power Tiger™
38
Part No 1134839
Installing/Removing T-Arms
NOTE: For this procedure, refer to FIGURE 6.9 on page 38.
Installing T-Arms
1. Position the T-arm over the T-arm socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards the front of the wheelchair.
2. Slide T-arm into T-arm socket until the locking lever is in the slot in the T-arm socket
and an audible "click" is heard.
3. Pull up on T-arm to make sure T-arm is locked in place.
NOTE: If the T-arm does not slide in the T-arm socket as desired, contact a qualified technician.
4. Adjust the T-arm for desired height. Refer to Adjusting T-Arm Height on page 39.
NOTE: If width and/or depth adjustments are necessary, contact a qualified technician.
5. Repeat STEPS 1-4
for opposite side of wheelchair.
Removing T-Arms
1. Press in on the locking lever and lift the T-arm straight up and out of the T-arm socket.
NOTE: If the T-arm does not slide up and down in the T-arm socket as desired, contact a qualified
technician.
2. Repeat STEP 1
for opposite side of the wheelchair.
FIGURE 6.9
Installing/Removing T-Arms
Locking Lever
(Towards the front
of the wheelchair)
Wheelchair
Frame
T-Arm
T-Arm
Socket
Slot
