Orion
1.
Slacken brake cable using setting screw
A
.
2.
Disconnect brake cable at wheel
B
.
3.
Disconnect brake cable at brake lever on steering
column.
4.
Route brake cable through shroud.
5.
Loosen brake lever screw
C
at wheel.
6.
Replace brake cable.
7.
Install parts in reverse order.
8.
Test braking function while pushing.
4.9.3 Replacing steering link/coupling rod
CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When disassembling, note the position of small parts
such as screws and washers. Put small parts down so
that they can be reassembled in the right sequence.
•
10 mm wrench
•
12 mm wrench
•
13 mm wrench
•
Phillips screwdriver
•
Circlip pliers
•
Supporting wooden block
1.
Remove seat.
2.
Remove shroud.
3.
Disconnect battery cable
A
.
4.
Remove steering column and chassis. See 4.8.5 Replacing
steering column, page 22.
Replacing steering link/coupling rod
1.
Remove circlip (1) on steering link (2).
2.
Replace steering link.
3.
Adjust length of steering link using setting screws (3).
4.
Remove circlip (4) on coupling rod (5).
5.
Replace coupling rod.
6.
Install steering link and/or coupling rod in reverse order.
7.
Test function (trial run).
Adjusting camber
1.
Loosen screws
A
.
2.
Spin steering link up by 0,5 cm. Wheels stand turned
inwards by 1°
C
from neutral position
B
.
3.
Install parts of steering link and/or coupling rod in
reverse order.
4.
Test all functions (trial run).
4.9.4 Replacing curve control device
CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When disassembling, note the position of small parts
such as screws and washers. Put small parts down so
that they can be reassembled in the right sequence.
•
Phillips screwdriver
•
32 mm wrench
1.
Remove seat.
2.
Remove shroud.
26
1608032-A