SECTION 9—WHEELS AND CASTERS
Lynx™L-3X
32
Part No. 1145807
SECTION 9—WHEELS AND CASTERS
WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power Off and
remove key from ignition.
Removing/Installing the Drive Wheels
NOTE:
For
this
procedure,
refer
to
FIGURE 9.1
on
page 33.
Removing
1. Turn
power
off
and
remove
the
key
from
the
ignition.
2. Remove
the
seat.
Refer
to
Removing/Installing
the
Seat
on
page 27.
3. Place
the
rear
frame
assembly
(not
shown)
up
on
blocks
so
that
the
drive
wheels
are
off
the
ground.
4. Remove
the
cap,
nut,
large
washer
and
small
washer
that
secure
the
drive
wheel
to
the
drive
shaft.
5. Remove
the
existing
drive
wheel
assembly
from
the
drive
shaft.
NOTE:
Use
a
wheel
puller
if
necessary
to
remove
the
wheel
from
the
drive
shaft.
6. Remove
keystock
from
drive
shaft.
Set
aside.
7. If
necessary,
repeat
STEPS
1
‐
6
to
remove
other
drive
wheel.
Installing
1. Place
keystock
in
cutout
on
drive
shaft
as
shown
in
FIGURE 9.1.
NOTE:
The
keystock
in
the
drive
shaft
MUST
lineup
with
the
cutout
in
the
wheel
hub.
NOTE:
If
necessary,
use
a
rubber
hammer
to
gently
tap
drive
wheel
completely
into
position
on
the
drive
shaft.
2. Install
the
drive
wheel
onto
the
drive
shaft.
3. Secure
wheel
to
drive
shaft
using
the
large
washer,
small
washer
and
nut.
Securely
tighten.
4. Install
the
cap
onto
the
nut.
5. Repeat
STEPS
1
‐
4
to
install
the
other
drive
wheel.
6. Install
the
seat.
Refer
to
Removing/Installing
the
Seat
on
page 27.
