Invacare LiNX REM400, Руководство пользователя, Страница: 44 / 101

60126081-C 43
1.
Swipe-and-Tap Mode Tap Mode
Slide the set point
E
up or down.
Tap the top or bottom of the
speed slider
D
. Plus and minus
symbols indicate where to tap.
The proportion of the green sections A and yellow
sections B on the speedometer and the speed slider
correspond to the position of the set point
E
.
As soon as you start driving, the speed slider and Navigation
button disappear from the display. The current speed on the
speedometer, if it is enabled.
The speedometer/odometer display is a new feature
introduced for LiNX MR6.0. It replaces the sweeping
speed gauge that wrapped around the speed dial.
l
If both the firmware and the configuration are
greater than version 5.1.10, the new
speedometer/odometer displays when it is
enabled.
l
If both the firmware and the configuration file are
less than or equal to version 5.1.10, the previous
speed indicator displays.
l
If the firmware is greater than version 5.1.10 and
the configuration file is less than or equal to
version 5.1.10, no speed indicator displays.
6.6 Using Latched Driving Mode
Latched driving modes allow you to latch (or maintain) a
forward or reverse speed so you can drive without continuously
providing a drive command.
Risk of Unintended Movement
When you send a forward or reverse command, the
wheelchair drives forward or reverse at a constant
speed and will continue driving at that constant
speed until one of the following occurs:
-the external stop switch is pressed (refer to
6.16.2
Through External Switches, page 55 )
-an emergency stop is performed (refer to 6.7 Using
Emergency Stop, page 47 )
-an opposite command is received (a reverse
command when driving forward or a forward
command when driving reverse)
-the Latch Drive Timeout is expired
To avoid potentially dangerous situations, Invacare
recommends to make yourself familiar with the
latched driving mode, especially with the commands to
stop the wheelchair.
6 Usage