7
VENTURE
®
HOMEFILL II COMPRESSOR
CONNECTING THE COMPRESSOR TO THE
CONCENTRATOR (FIGURE 3)
1. Insert one (1) end of the interconnect hose into the outlet fitting on the back of the
concentrator.
2. Insert the opposite end of the interconnect hose into the inlet fitting on the side of the
compressor.
NOTE: The metal tabs on the concentrator outlet fitting and the compressor inlet fitting will pop out with
an audible click when the end of the interconnect hose is properly installed.
3. Loop any excess interconnect hose and secure to the back of the concentrator with the
fastening straps.
FIGURE 3 - CONNECTING THE COMPRESSOR TO THE
CONCENTRATOR
FIGURE 2 -INSTALLING THE POWER CORD
Electric Connector
Power Cord
Compressor
(REAR)
Wall Outlet
Inlet
Fitting
Compressor
Inlet/Outlet Fitting
Metal Tab
Interconnect Hose
Insert End of Interconnect
Hose into Inlet/Outlet Fitting
PROCEDURE 2
INITIAL SETUP
INSTALLING THE POWER CORD (FIGURE 2)
1. Ensure the compressor is on a hard flat stable surface, such as a table.
2. Plug the power cord into the electric connector in the back of the compressor.
3. Plug the opposite end of the power cord into the wall outlet.
INITIAL
SETUP
Concentrator
Outlet Fitting
All manuals and user guides at all-guides.com
