SECTION 9—ANTI-TIPPERS
Part No 1100868
51
9000 Jymni™Pediatric Series
SECTION 9—ANTI-TIPPERS
WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
Installing/Adjusting the Anti-Tippers
WARNING
Anti-tippers are specific to the different rear wheels and/or seat-to-floor heights.
Refer to the chart in Installing/Adjusting the Anti-Tippers on page 51 for correct
usage and adjustment. If these requirements CANNOT be achieved, DO NOT use
the wheelchair. Contact an Invacare dealer or qualified technician. Any changes to
the seat-to-floor angle or seat-to-floor height may require different anti-tippers.
Seat-to-floor height (which includes changing rear wheel size): If changing the
seat-to-floor height with or without changing the rear wheel size, the correct
anti-tippers MUST be ordered to maintain a 1
½
to 2-inch ground clearance.
Non-recliners Only - Inasmuch as the anti-tippers are an option on this wheelchair
(You may order with or without the anti-tippers), Invacare strongly recommends
ordering the anti-tippers as an additional safeguard for the
wheelchair user.
Recliners and Wheelchairs with 1-Inch Forward Rear Wheel Positioners Only -
Anti-tippers MUST BE attached at all times.
Anti-tippers MUST be fully engaged. Ensure that the release buttons of the
anti-tipper fully protrudes out of the hole on the bottom of the wheelchair frame
and out of hole in the adjustment tube.
Ensure both anti-tippers are adjusted to the same height.
Installing the Anti-Tippers
NOTE: For this procedure, refer to FIGURE 9.1.
NOTE: To ensure the correct model anti-tipper is used refer to the Anti-tipper Identification Chart
bellow. Measurements for anti-tippers are approximate and are taken with extension tube in top
hole position (Detail “A”).
ANTI-TIPPER IDENTIFICATION CHART
REAR WHEEL
SIZE
ANTI-TIPPER
LENGTH
ANTI-TIPPER
PART NUMBER
20 inch Rear Wheels
9 inches
1101959
22 inch Rear Wheels
9-5/8 inches
1058752
