Intuitive Aerial newton, Руководство пользователя

Страница: 19 / 24

NEWTON 15
USER MANUAL
4 Troubleshooting
Problem Possible Cause(s) Solution(s)
Newton does not start up Batteries are empty Exchange to fully charged batteries
No external power con-
nected Connect external power supply to New-
ton
Dominion does not es-
tablish connection with
Newton Antennas are not
mounted
Mount antennas
Dominion and Newton
are not paired Perform pairing procedure, see Domin-
ion manual
There is a constant drift
in pan, tilt or roll Input calibration is not
properly done Immediate solution: Use deadband set-
ting to compensate. See Dominion user
manual or contact support for instruc-
tions on how to redo calibration
There is a very small drift
present in pan due to gyro
bias Activate the trim functionality to elimi-
nate drift manually, see Dominion man-
ual
Camera/lens interface
dongle is not recognized
by Dominion
Dongle has incompatible
firmware Update dongle firmware to same version
as Dominion
Communication link is
not established between
Newton and Dominion See entry above
There is a small constant
offset on either roll or tilt IMU or cradle not per-
fectly orthogonal Adjust the roll or tilt angle correction.
See section
2.6.3 .
Display shows “IMU
BIAS CALIB FAILED”
Newton was not still dur-
ing startup. It might lead
to reduced performance Restart Newton, make sure not to disturb
the camera until display shows “STOW”
DO NOT DISTRIBUTE
Copyright © 2016 Intuitive Aerial AB