N-2
5. If possible, remove any cushions from the boat. After cleaning store the cushions in a
dry and ventilated place. If the cushions need to be left aboard stand the cushions on
one side to provide some ventilation.
6. If your mooring lines are natural fiber store the lines in a dry and ventilated place.
7. Apply a protective spray (CRC or WD-40 for example) on metal parts. Do not spray
any rubber or leather surfaces.
8. Inspect the hardware on your boat, the propellers in particular. Repair or replace
defective parts now.
9. Ensure that any linkage or moving parts of the steering or engine control systems are
free and well lubricated.
10. Provide a method to keep your batteries charged.
LAUNCHING YOUR INTREPID
Completing the checklist list below during the launching of your boat after being in storage will
help make launch a successful one.
Pre Launch
1. Install the garboard drain at the lowest point of the transom.
2. Thru-hulls and strainers must be secure and free of debris.
3. Secure the propeller nuts.
4. Check all seacocks to ensure they operate completely and freely. Close the seacocks
before launching the boat
5. Test the Bilge Pumps for proper operation in both manual and automatic modes.
6. Check the batteries to ensure they are secure, have been properly maintained and
are fully charged.
7. Check all electrical accessories for proper operation.
8. Check all Fuel System fittings and plumbing to ensure tightness and there are no
leaks.
9. Check the engine oil reservoirs to ensure they are at proper capacity.
AFTER LAUNCH
1. Check for any water leaks.
2. Check the Steering Reservoir for proper level of steering fluid. Operate the steering
system to check that it operates freely and through the full range of motion.
3. After starting the engines check for proper gauge indications and engine throttle and
shift operation.
