INTORQ BFK470 Series, Перевод оригинальной инструкции по эксплуатации

Страница: 24 / 52

Mechanical installation
INTORQ | BA 14.0199 | 08/2016 24
2. Slide the brake onto the shaft.
- Align supplied socket head cap screws (10) with fixing holes in the end shield (15).
3. Use a torque key to tighten the socket head cap screws (10) with the required tightening torque, 15.
NOTICE
When using a shaft seal, the brake has to be mounted so that it is centred properly!
The shaft diameter must be implemented in accordance with ISO tolerance h11, with a radial
eccentricity tolerance according to IT8 and an averaged surface roughness of Rz

3.2 µm in
the sealing area.
NOTICE
Please note the following for the version "brake with shaft sealing ring":
❚
Lightly lubricate the lip of the shaft seal with grease.
❚
No grease should be allowed to contact the friction surfaces.
❚
When assembling the stator, push the shaft sealing ring carefully over the shaft. The shaft
should be located concentrically to the shaft seal.
NOTICE
The customer must seal the brake in this position himself if no shaft seal or cover is in use.
NOTICE
If it is necessary to loosen the screws with the seal again, the seals or the complete screw set
must be replaced.