94626 1 10/17
GB
11
FlashEx
7
= Pilot lamp
„Ready“
Continously lights when the mains switch (Fig. 1)
is operated.
„Motor protection“
Flashes when the motor is overloaded. While the
motor is cooling down, the machine cannot be
switched on to „forward“ run.
8
= Pilot lamp "Material jam"
Lights when too much material is fed to the cut-
ters (see description
„Automatic response in case of
„overloading““, p. 12
).
9
= Pilot lamp
„Door open“/„Safety glass open“
Lights when the door is not closed or when the sa-
fety glass (Fig. 3/1) is open. The machine then swit-
ches off automatically and it cannot be started as
long as the door is open or the safety glass is open.
„Catch basket full“
Lights as soon as the catch basket is full and needs
to be emptied. At the same time the machine swit-
ches off automatically.
3 .3 "Feed slot" operator unit
1
000087
2
1
Safety glass
2
Feed flap
Fig. 3 intimus FlashEx feed slot
1
= Safety glass (Fig . 3/1)
The machine only runs if the safety glass is closed.
2
= Feed flap (Fig . 3/2)
Feed the material through the device's feed flap.
This starts the cutting mechanism.
3 .4 Turning the machine on
To start, switch on the unit by operating the main
switch (Fig. 1).
¾
The pilot lamp marked „ready for operation“
(Fig. 2/7), as well as the red stop-button „S“
(Fig. 2/3) will light to indicate that the machine
is ready for operation.
¾
You can now feed the machine.
3 .5 Starting the shredding process
DANGER!
Risk of injury! Damage to the machine!
)
Remove batteries from the device befo-
re shredding it!
CAUTION!
Material jam! Damage to the machine!
Ì
Feed the data carriers into the machine
individually, one after another! This lets
the
intimus FlashEx
reach its best per-
formance.
Ì
If too much material has reached the
cutting mechanism, see
„Material jam“,
p. 13
.
Feeding through the feed flap (Fig . 4/2)
Slip small data carriers, like USB sticks, mobile phones
or SSD disks, through the feed flap into the cutting me-
chanism.
¾
The shredding process starts automatically.
¾
After destroying the data carrier, press the stop-
button „S“ (Fig. 2/3).
1
000084
2
1
Safety glass
2
Feed flap
Fig. 4 Feeding through the feed flap
Feeding through the safety glass (Fig . 4/1)
1 .
For larger data carriers, e.g. mini tablets, push the
safety glass back and feed the data carrier into the
cutting mechanism.
2 .
Close the safety glass again.
3 .
Briefly press the forward-button Fig. 2/2.
¾
The shredding process starts.
¾
After destroying the data carrier, press the stop-
button „S“ (Fig. 2/3).
