163
SAVE THESE INSTRUCTIONS
Page 27
(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U
09/18/2010
English
MM
AA
IINN
TT
EE
NN
AA
NN
CC
EE
MOTOR PRE-FILTER CLEANING AND MAINTENANCE
1.
Make sure the filter pump is switched off, then disconnect the power cord from
the electrical outlet.
2.
Grasp a plunger valve handle. Turn the handle counter-clockwise, push down
until it stops and then turn it clockwise until the plastic protruding notch anchors
in the "0/1" position. Repeat for the second plunger valve. This prevents the
water from flowing out of the pool.
3.
Release the pressure first by opening the
sediment release valve
(
19
)
located
on the lower side of the pre-filter housing
(see
drawing 35
)
.
4.
In a counter-clockwise motion unscrew the
leaf trap cover
(
14
)
, then remove the
basket
(
16
)
and leaf trap o-ring
(
15
)
from the
pre-filter housing
(see
drawing 36
)
.
5.
Empty and flush the basket using a garden
hose, may use a plastic brush to remove
deposits from the basket. Do not use metal
brush.
6.
Clean and rinse the inside of the pre-filter
housing and the leaf trap O-ring with
a garden hose.
7.
Reinstall the leaf trap O-ring, basket and leaf
trap cover to the pre-filter housing.
8.
Close the sediment release valve
(
19
)
back.
1
2
35
36
F
FLLO
OW
W S
SE
EN
NS
SO
OR
R C
CLLE
EA
AN
NIIN
NG
G
19
14
16
15
1
.
In a counter-clockwise motion unscrew the collar of the flow sensor
(
21
)
and remove it from the electrolytic cell conduit
(
22
)
. See “Part Reference”.
2
. If deposits and debris are seen on the surface of the flow sensor, then use
a garden hose to wash it off.
3
.
If flushing with water does not remove the deposits, use a plastic brush to
clean the surface and the hinge if necessary. Do not use a metal brush.
4
. After the flow sensor has been inspected and cleaned, align the locator
notch on the flow sensor to the connection ridge in the conduit. Now turn
the collar in a clockwise motion, tightening the sensor back into its position.
Do not overtighten.
Connection Ridge
Locator Notch
Hinge