LED PANEL
TROUBLESHOOTING GUIDE (continued)
CODE
PROBLEM
SOLUTION
LED Panel Code Flash & Alarm On (
NOTE
: Always turn off the power before cleaning and servicing).
1
. Circulation line is blocked.
•
If your unit has plunger valves, ensure
that they are open.
- Clear your basket and cell of debris and dirt. See “Maintenance”
- Depress the 6-way valve, release all
2
. Incorrect inlet and outlet hose
trapped air in the circulation line.
•
Check the direction of the inlet and the
direction.
3
. Scale on the flow sensor.
outlet hose. Reverse the hoses if
necessary. See “Set Up Instructions”.
•
Clean the flow sensor, paying special
4
. Flow sensor cord is loose.
attention to the hinge. See
“Maintenance”.
•
Plug the flow sensor firmly into the flow
5
. Flow sensor failure.
1
. Dirt or scale on titanium plates.
2
. Low salt level / No salt.
sensor receptacle.
•
Contact Intex Service Center.
•
Remove the electrolytic cell for
inspection. Clean it if necessary.
See “Maintenance”.
•
Add salt. See “Salt & Pool Water
3
. Electrolytic cell cord is loose.
4
. Possible electrolytic cell failure.
Volumes”.
•
Ensure that the cell cord is plugged
firmly into the cell housing receptacle.
•
Contact Intex Service Center. Replace
1
. High salt level.
the cell if needed.
•
Partially drain the pool and refill it with
1
. Display and all lights are off - the
system does not power up.
fresh water. See “Salt & Pool Water
Volumes”.
•
Household voltage is too high or too low
(+ 20%). Check the voltage is within the
Range stated on the device housing.
- Contact Intex Service Centre
SAVE THESE INSTRUCTIONS