7
3. General safety instructions
The live components have to be installed only by a qualified electrician. In
case of failure of the electronic device, the product has to be repaired by a
qualified electrician before being operated again. There is a risk of electric
shock!
The outlet circuit used for the device has to be secured through a circuit
breaker protected (16 A in several countries). If unavailable, an FI switch with
maximum operating current of 30 mA has to be connected.
When working inside of the tank or on electrical components always unplug
the power cord first.
National rules and electrical standards must be considered!
These installation and operating guidelines have to be read carefully before
installing the product. The instructions mentioned have to be followed strictly.
Modifications to the product are not permitted, otherwise the warranty
becomes void.
National rules and safety standards must be considered!
The following points have to be strictly observed during the installation and operation:
Check the product before installation for any visible defects. If defects are present, then the
product must not be installed. A damaged product can be dangerous.
A floor drain has to be provided near the installation site, which can collect inadvertent water
discharge (such as with pump defect, pipe breakage etc.) and prevent water damage inside the
building. The brickwork behind the tank installation position must be protected from water
(such as with water-resistant paint).
Make sure that the existing emergency overflows are connected and adequately sized.
All products must be regularly inspected to maintain proper condition. The minimum inspection
interval is mentioned in the maintenance chapter.
Electric devices may be hazardous for children. Therefore children always have to be kept away
from the product. Do not let children play with the product.
Do not install the water-carrying products in locations where the temperature may drop below
0 °C.
Do not install any electric products in flood-prone areas.
The operator is responsible for adherence of the safety and installation guidelines
Access ports of the tank system shall be protected against unauthorized intrusions (e.g. lockable
plant room, a padlock, locking the cover with specialized tools or cover with net weight > 30 kg).
The national and local regulations with regards to the installation and operation of a
grey water treatment system must be complied by the installer as well as the operator.
