MicroVista Camera User Manual
Imaging Support: [email protected] http://www.mosir950.com 408-496-2019
17
Troubleshooting
If the camera does not operate (no video signal) after 30 seconds, check the
following:
1.
Are all cables correctly and securely connected?
2.
Is the power supply working with a proper voltage?
3.
Is the lens cap removed, the iris open and the focus properly set?
4.
Are the frame grabber card and PC set up and functioning properly?
If the camera is not responding to GUI commands, check the following:
1.
Camera is receiving power.
2.
Check port settings. If using RS-232, settings should read as shown
in Figure 7: COM Port Properties Window. If using Camera Link
serial, the bits per second should be set to 38400. (The MicroVista
®
GUI attempts to set this automatically, but some frame grabbers may
need to be set manually.)
Figure 7: COM Port Properties Window
3.
Once settings are properly configured, cycle the power (disconnect/
reconnect) and re-attempt to connect to the camera.
38400
