Intertek Pinnacle PB150, Инструкция по установке и эксплуатации

Страница: 8 / 30

7
PRIMARY CONTROL 0II350S
SEQUENCE OF OPERATION
3A 250V
When the wall thermostat circuit is closed, and calling for
heat, the light indicator will remain dim as long as the
circuit is closed. When the thermostat is open (not calling
for heat) the light will blink from bright to dim every 15
seconds as part of the counting procedure.
The computer board is protected by an AGC 3-amp fuse.
There are many manufacturers of this fuse. Fuses are
readily available at your local hardware or auto parts
store.
FUSE
RED LIGHT INDICATOR
15 SECOND ON/OFF
Power In
The On Time controls the amount of time the burner stays
active (fuel is fed). It operates in conjunction with the
cycle time and is pre-set in the control at 2
minutes
The PILOT CYCLE time switch controls the total cycle both
on and off, 8 or 16 minutes.
The On Time is subtracted by the Cycle Time Example:
With the On Time pre-set at 2 minutes and the Cycle Time
set at 16 minutes, the unit would come on (feed corn) for
2 minutes and not feed corn for 14 minutes. This gives
you a complete cycle time of 16 minutes.
The 0II350S primary control has 6 lead wires. A wiring
colour code is provided on back of each control. Black is
line power. White is neutral. Red is load and feeds the
auger motor and cup motor. Orange feeds the draft
inducer. 2 yellows go to the wall thermostat.
The POWER switch cuts power to burner but not blower
fan system and to shut the furnace down.
The PILOT DRAFT switch controls the speed of the draft
inducer on pilot or idle mode. Normally set on Medium,
but will vary with differing chimney configurations.
ON TIME (2MINUTES)
PILOT DRAFT SWITCH
POWER SWITCH
WIRING
COMBINATION FUNCTION OF
ON TIME AND CYCLE TIME
PILOT CYCLE TIME
SWITCH
The Traeger 0II350S primary
control is a high-tech, state of
the art computer. The control
performs the function of
piloting the system when the
thermostat does not call for
heat. It conserves fuel
consumption.