Interroll RollerDrive EC5000 AI, Руководство по эксплуатации

Страница: 40 / 54

40 of 54
Version 2.4 (03/2020) Online
Translation of the original operating manual
Assembly and installation
5 Assembly and installation
5.1 Warning notices for installation
WARNING
Risk of electric shock!
When using the RollerDrive EC5000 48 V DC, it is possible that in generator operation (motor revolution
14.500 min-1 / gear reduction) the permissible contact voltage of 60 V DC at the open connector is exceeded.
¾
Do not drive unconnected RollerDrive from the outside.
For the RollerDrive EC5000 24 V DC, exceeding the permissible contact voltage is only theoretically
possible.
CAUTION
Risk of crushing due to rotating parts.
¾
Do not place your fingers between the RollerDrive and the round belt/PolyVee belt.
¾
Install protective equipment (e.g. Interroll PolyVee finger guard) to prevent fingers from getting caught in the
PolyVee belt or round belt.
¾
Affix suitable warning notices/pictograms to the conveyor.
NOTE
An improper approach to installing the RollerDrive can lead to material damage or reduce the service life of the
RollerDrive.
¾
To preserve the interior of the RollerDrive, do not allow the RollerDrive to fall or for it to be used in an
improper fashion.
¾
Check each RollerDrive before assembly for any visible damage.
¾
To prevent the inner connections from being damaged, do not hold, carry or secure the RollerDrive by the
cable.
¾
Do not use force to insert the RollerDrive into the side profile. It must be inserted gently into the side profile.
¾
Pay attention to the correct tightening torque of the RollerDrive hexagonal nut to prevent the shaft in the
side profile from rotating and the RollerDrive cable from twisting (see „Securing the RollerDrive in the side
profile“ on page 43 ).
¾
Do not twist the RollerDrive cable.