
Interroll Diverter SH 1500
Maintenance and repair
Version 1.0 (06/2022) en
Translation of original operating instructions
55
Requirement:
R
The module is shut down.
4
Disconnect the drum motor (7) from the power supply (detach it).
4
Remove the side covers,
see "Removing/installing the side plates", page 51
.
4
Remove screws (5) from cable tie holders (6) at the side frames (8) and attach new cable tie
holders (6) at the side frames (8).
4
Properly dispose of the old cable tie holders.
4
Attach new cable tie holders (6) at the side frames (8).
4
Remove screws (1) from cable sleeves (3) and detach cable sleeve from the side frame (8).
4
Remove screws (3) on the right and left from the side frames (8) of the module from the two
threaded plates (4) in each case and remove them.
4
Properly dispose of the old cable sleeve and threaded plates.
4
Attach new threaded plates (4) as holders on both sides of the drum motor (7) and fasten
with screws (3).
4
Fasten new cable sleeve (2) with screws (1) on the cable side of the drive drum.
4
Reattach the side covers.
4
Connect the drum motor to the power supply (clamp it).