Interphase ENTIA 5536 DM PRI, Руководство пользователя

Страница: 131 / 244

Chapter 7: Managing Serial Driver COM Ports
5536 PRI RAS Communications Controller Users Guide
111
4. When you are prompted to choose a port on which to
run detection, select the port where you want to declare
a modem.
Serial driver COM ports are named COM
ixx
, where i is
the card number and xx is the port number. Card
numbers start with 0 ; port numbers start with 01 .
To be available, Serial driver COM ports must be
assigned to the board. By default, eight Serial driver
COM ports (
COM
i
01 – COM
i
08 ) are assigned to each
5536-DM WAN board. (You can change COM port
assignments using the WAN Adapters Setup utility. For
information, see
Setting Up Card Properties on page
77 .)
5. Click Next .
A message asks you to wait while Windows NT
attempts to detect your modem.
6. If a modem is not detected, and you are prompted to
select your modem from a list, do the following:
a. Click Next to display a list of modem manufacturers
and models.
b. Select Interphase in the Manufacturers list, and
select Interphase Digital Modem in the Models
list. Then click Next .
7. When you are asked on which port to install the modem,
select this or any other digital modem port(s) to be used
as the serial modem port(s). Then click
Next .
8. When you are informed that you will need to restart the
system before you can use the modem on the ports, click
OK to continue.