Interpack ETII+ LD, Руководство пользователя

Страница: 30 / 73

UH178TW / UH678TW UDH178-01
30
P
REVENTIVE
M
AINTENANCE
UUU
Spring Replacements
There are 3 springs on the HSD 2000-ET II LD. These springs are wear items and should be inspected
regularly and replaced if necessary. Below are instructions for replacing the two most common springs.
Main Spring Replacement
1. Using a pair of needle nose pliers, remove
one end of the main spring from the
retainer ring.
2. Take off the damaged spring.
3. Hook one end of the new spring over the
retaining ring in the middle
4. Stretch the spring over rear arms spring
retainer ring using either needle nose
pliers or your finger. Hook the loop
securely into the retainers groove.
Figure 10-7
Knife Arm Spring Adjustment
Should the Knife Arm Cutting Force need to be
adjusted, follow the procedure below.
1. To increase the force, using a 10mm open
end wrench, turn the 6mm nut clockwise
until desired pressure achieved. Lock into
the new position with the second nut.
2. To decrease the force, using a 10mm
open end wrench loosen lock nut first.
Turn it counter clockwise. Follow up with
the first nut counter clockwise as well, till it
is locked into the new position.
Figure 10-8