Intermec Trakker Antares 2420, Руководство пользователя, Страница: 430 / 480

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual nugget
D-4
Defining the Emulation Features of EM9560.BIN
The T242X is a programmable terminal that runs C/C++ applications. With the
EM9560.BIN
application, you can use the terminal as a remote input/output terminal in
which all prompts and commands are controlled by the host computer. With this
application, the terminal is similar to a 95XX in Data Entry mode with no application
running.
Note: For the 95XXs, Data Entry mode with no application running is also referred to
as an unprogrammed state or 95XX dumb terminal mode.
The
EM9560.BIN
application lets you use the terminal to emulate these specific 95XX
features:
•
An Enter key without any preceding data transmits an empty data packet.
•
The T242X display is similar to but not identical to the 9560 buffered display mode.
•
All function keys transmit the corresponding characters F1 , F2 , and so on.
•
When Code 128 is configured for Standard Code 128 symbology and you scan a
UCC/EAN label, the terminal will discard the Function 1 characters. Although this
does not meet the industry standard for Code 128, it does emulate the 95XX, which
was manufactured before the current standard was established. Other Code 128
configurations work as defined in this user’s manual.
•
The Set Time and Date reader (data entry) command is supported. When the terminal
receives a time broadcast command (/+) from the 9154 or 9161 controller, the
command sets the clock on the terminal.
Note: With Version 5.X firmware or later, the Set Time and Date reader command
is supported through the firmware and not just in the EM9560.BIN application.
•
The High Beep reader command is supported. When a backslash character (\) is sent
to the terminal through any serial or network port, the terminal sounds a high beep.
•
The Low Beep reader command is supported. When the BEL character is sent to the
terminal through any serial or network port, the terminal sounds a low beep.
•
When control codes (ANSI escape sequences) are sent to the terminal through any
serial or network port, the terminal formats the display. For a list of control codes,
see “Using Display Control Codes” later in this appendix.
•
Preamble A, Preamble B, and Postamble C are supported through the AA, AB, and
AC configuration commands or through the reader co., ++, and +%. For
help, see “Setting Preambles and Postambles” later in this appendix.
•
Full ASCII mode for Code 39 can be configured through the CB or RB configuration
commands or through the reader co$ and -$. For help, see “Full ASCII
Mode for Code 39” later in this appendix.
•
The Exit Configuration Mode, Save Settings configuration command ($-) is not
required, but bar code labels with this command scan correctly.