Intermec Trakker Antares 2420, Руководство пользователя

Страница: 204 / 480

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual Nugget
Co de 39
6-12
Problems While Configuring the Terminal (continued)
Problem Solution
You scan a configuration command, such as
Keypad Caps Lock, and you hear three low
beeps. If you are working in the TRAKKER Antares 2400 Menu System, you
cannot scan configuration commands. Use the Configuration Menu to
change the terminal’s configuration, or exit the menu system to scan
configuration commands.
You scan a configuration command, such as
Keypad Caps Lock, and nothing happens. There are two possible solutions:
•
You may have one or more reader commands disabled, such as
Change Configuration, so that you cannot change the
configuration. Enable all of the reader commands and try again.
•
The terminal may be waiting for another command to complete the
configuration change. If you started by scanning the Enter
Accumulate command, you must finish the command by scanning
the Exit Accumulate command. For help, see Chapter 9,
“Configuration Command Reference.”
Scan the Enable Override to temporarily enable all of the reader
commands. When you are finished, remember to disable the override
so that your data is not interpreted as a command.
Enable Override
*$+DC3*
*$+DC3*
On the T2425, you scan a configuration
command to set one of these parameters and
hear three low beeps:
•
Controller IP Address (UDP Plus)
or Host IP Address (TCP/IP)
•
Terminal IP Address
•
Default Router
•
Network Activate
If the Network Activate command is enabled (2.4 GHz RF network
enabled) and you are configuring the T2425, these addresses must
define a valid network configuration. For example, an invalid network
configuration would be a controller (or host) IP address set to 0.0.0.0
with the network enabled.
To set these four parameters, follow these steps:
1. Disable the Network Activate (NA) configuration command.
2. Set the terminal IP address and the controller IP address or the host
IP address.
3. Set the default router address (if necessary).
4. Enable the Network Activate command.
You can change an IP address with the network enabled as long as it
still defines a valid network configuration.