Intermec PB51, Руководство пользователя

Страница: 42 / 72

Chapter 2 — Configuring the PB51
32 PB51 Mobile Label and Receipt Printer User’s Guide
To configure the printer to use WPA-PSK or WPA2-PSK mode
1 Send the following commands to login as an admin an d set the
SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID,
xxxxx
<ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
2
Send one of the following commands to turn on WPA o r WPA2
authentication. Send the WPA-PSK or WPA2-PSK comman d to set
a pre-shared key:
<STX><SI>ws,WPA,ON<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK,
xxxxxxxxxx
<ETX>
where xxxxxxxxxx is a value between 8 and 64 characters.
3
Send the following command to activate the settings:
<STX><SI>ws,ACTIVE,1<ETX>
To configure the PB51 to use WPA or WPA2 Enterprise mode
1 Send the following commands to login as an admin an d set the
SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID,
xxxxx
<ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
2
Send one of the following commands to enable WPA-802.1x or
WPA2-802.1x authentication. You should also send th e WPA_PSK
command that does not contain a value:
<STX><SI>ws,WPA,ON<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, <ETX>
3 Send these commands to configure the EAP_TYPE:
<STX><SI>ws,EAP_TYPE,
xxxx
<ETX>
where xxxx can be OFF, LEAP, PEAP, or TTLS.
<STX><SI>ws,.EAP_USER,
xxxx
<ETX>
<STX><SI>ws,.EAP_PASS,
xxxx
<ETX>
Note:
The default password for logging in as an admin is “pass.” If
you have changed the password, you will need to use your password
instead of “pass.”