Intermec Janus 2010, Руководство пользователя, Страница: 142 / 558

JANUS 2010 Hand-Held Computer User’s Manual
4-16
Configuring the Reader to Use an ATA Card
1. Edit the CONFIG.SYS file on the reader’s drive C.
Note: You cannot edit the file directly on the reader’s drive C because drive C is a
ROM drive resident in flash memory. For help, see “Learning How to Change the
Contents of Drive C” in Chapter 3.
2. Search for these lines in the CONFIG.SYS file:
device=c:\atadrv.exe /s:2
device=c:\mtddrv.exe
device=d:\cardid.exe d:\cardid.ini
If the lines are remarked out, delete the REM characters. If you cannot find
these lines, add them to the CONFIG.SYS file.
3. To save conventional memory, remark out any lines that load drivers for
flash, I/O, or SRAM cards. For a list of card drivers, see “Managing the PC
Card Drivers in the Startup Files” later in this chapter.
4. Save your changes to the CONFIG.SYS file.
5. Replace the CONFIG.SYS file on the reader’s drive C.
Initializing and Formatting an ATA Card
1. Insert the ATA card in the PC card drive.
2. Type this command at the DOS prompt:
atainit { drive :}
where drive is the PC card drive.
Note:
ATAINIT only works with ATA cards that are supported by the
ATADRV.EXE driver. If you are unable to use your ATA card, it may be an
unsupported card. Check the documentation that COMES with the ATA card.
Caution
Make sure you enter the correct drive letter when you initialize the ATA card
or you may erase the wrong drive.
Conseil
Assurez-vous de ne pas faire d’erreur en tapant la lettre identifiant le lecteur
pour le formatage de la carte ATA. Sinon, vous risquez d’effacer un lecteur
incorrect.