Intermec EasyCoder PD4, Руководство по обслуживанию

Страница: 102 / 114

92 Intermec EasyCoder PD4—Service Manual
Chapter 14—Troubleshooting
When printing, page skipping occurs Check label height setting (Q command) Programmer’s Ref-
erence Manual
Check if label gap sensor is disturbed by media or dust Chapter 14.7
Weak printout Check density setting User’s Guide
Check if thermal printhead needs cleaning User’s Guide
Check printhead pressure Chapter 7.7
Check printhead dot line position Chapter 7.7
Uneven darkness across media path Check printhead balance Chapter 7.7
When using cutter, label was not cut
straight Check if media is loaded correctly User’s Guide
When using cutter, label was not cut
successfully Check if media is loaded correctly User’s Guide
Check that media thickness does not exceed 250 µm (9.8
mils)
When using cutter, label could not
feed or abnormal cutting occurs Check if cutter is installed properly Chapter 10.1
Check if paper feed rods are sticky. Clean if necessary
using isopropyl alcohol.
When using stripper, abnormal func-
tion occurs Check if stripper full sensor is working Chapter 9.1
Check if media is loaded properly User’s Guide