Intermec EasyCoder 4420, Руководство пользователя

Страница: 81 / 156

code39
Optimizing Printer Performance
5-11
5
Adjusting the Label Gap Sensor
If you experience problems such as the printer skipping labels or the printer
stopping and the yellow LED flashing, you may need to adjust the label gap
sensor. You are most likely to experience any of these problems if you are using
very narrow label stock and the label gap sensor is not in the correct position.
You can adjust the label gap sensor from 0 to 1.0 inch from the inner edge of the
printer.
Note: Intermec sets the label gap sensor to 0.5 inch from the inner edge of the printer at
the factory. You should be able to leave it in this position for most labels wider than 1.0
inch.
To adjust the label gap sensor
1. Remove the media cover.
2. Turn the label gap sensor knob approximately 1/2 turn counterclockwise to
free the sensor for adjustment.
3. Slide the label gap sensor knob to the position where the label gap sensor is
optimized for your label stock.
Here are some guidelines for you to follow:
•
If your labels are less than 1.0 inch wide, position the label gap sensor in
the middle of the label.
•
If your labels are greater than 1.0 inch wide, position the label gap
sensor over the straight edge of the label (not over the label radius).