Intermec EasyCoder 4420, Руководство пользователя

Страница: 20 / 156

4420 and 4440 Bar Code Label Printer User’s Manual
1-8
4. Place the fanfold media slightly lower than the slot in the printer back
cover. Align the fanfold media with the label path through the printer.
Insert media through the slot at the rear of the printer and thread it over the
supply roll post.
5. Unscrew the edge guide and slide it to the outer edge of the lower media
guide. Screw it in place.
6. Pull down on the lower media guide to allow easy access to the media path.
7. Insert the fanfold media through the printer mechanism as shown in the
illustration. The fanfold media passes over the supply roll post and out the
front opening of the printer.
8. Release the lower media guide and adjust the edge guide to position the
media firmly against the inside wall of the printer.
9. Slide the supply roll retainer up to the edge of the fanfold media and turn
the supply roll retainer clockwise until it locks firmly in place. This action
secures the media against the inside wall of the printer.
10. Rotate the head lift lever counterclockwise until it locks to engage the
printhead.
11. Replace the media cover.
12. Press the Feed/Pause button to advance one label through the printer.
The yellow Empty/Pause LED goes out. The printer is now ready to print the
configuration test label.
Note: If the yellow Empty/Pause LED does not go out, reload the media and try again.
Note: For your convenience, refer to the label with directions for loading media located
on the inside of the media cover the next time you load media.