Intermec EasyCoder 4100, Руководство пользователя

Страница: 101 / 282

4
4-13
Routine Maintenance
Helvitica condensed 9 pt italic
Co d e 39 18 p t
3. To align the opposite end of the printhead, turn the alignment plate upside
down and insert the contoured edge into the space along the left end of the
printhead.
4. When the alignment plate is seated against the metal shoulders of the upper
and lower drive rollers, use hex key to adjust the right printhead adjust
screw. Move the printhead forward until it just touches the edge of the
alignment plate.
The printhead should now be aligned roughly so that the print line is centered
on the drive roller. Print quality at this point should be fairly good. To
optimize the print quality, perform the following fine adjustment procedure.
To adjust the printhead alignment for a fine adjustment
1. Print bar codes on a label and inspect the printing quality.
2. Use the hex key to turn the left and right head adjust screws
counterclockwise 1/4 to 1/2 turn until you achieve the desired print quality.
3. Push the bearing block back into contact with the printhead support plate
and tighten the screws to secure the bearing block mounting bracket.
4. Turn the left head adjust screw 1/4 turn counterclockwise.
Replacing the Cutter Blade
The lifetime of the cutter blades is 1 million cuts, or 500,000 cuts per side. The
blades are reversible for extra life before replacement. The cutter blades cannot
be sharpened and must be replaced when both cutting edges become dull.
Replacement cutter blades are available for purchase from Intermec (Part No.
501137).
Tools Required: Phillips screwdriver, straight slot screwdriver, WD-40® or a
similar petroleum-based lubricant, silicone-based lubricant, Loctite® a thread-
locking adhesive, clean cloth or cotton swab.