background image

BEMS INTERFACE BOX

Installation Instructions

Federal Communications Commission (FCC) Notice for ET9500 BEMS INTERFACE BOX

Description:

This document explains the setup and configuration of the 
Intermatic model ET9500 BEMS INTERFACE BOX (Gateway).  The 
ET9500 allows for remote control (via computer application) of the 
circuits on the ET90000 series time switches through various 
forms of communication.  The communication protocols are the 
following: BACnet

®

, Modbus, and Metasys

®

 N2.

Follow these instructions to complete the installation of the 
ET9500 BEMS INTERFACE BOX (Gateway).

This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions: (1) This device 
may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired 
operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated 
in a commercial environment. This equipment generates, uses and radiates radio frequency energy and, if not installed and used in 
accordance with instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential 
area is likely to cause harmful interference that requires the user to correct at his or her own expense.

MODEL ET9500

• Disconnect power at the circuit breaker(s) or disconnect switch(es) before installing or servicing.
• Installation and/or wiring must be in accordance with national and local electrical code requirements.
• Use #18-#8 AWG wires, rated at least 90°C - COPPER conductors ONLY.
• For outdoor locations or wet locations (rain-tight), conduit hubs that comply with requirements of the UL514B (standard for fitting conduit and

outlet boxes) are to be used.

• KEEP DOOR CLOSED AT ALL TIMES when not servicing.
• Replace dead front after servicing or installation.

Risk of Fire or Electric Shock

     WARNING

Application notes:

• Thoroughly read instructions before installing.
•  Observe warnings and instructions on front panel and unit

label of product.

Specifications:

Input Voltage:

 120-277 VAC, 50/60 Hz

Power Consumption:

 3 W MAX

Shipping Weight:

 11.8 lbs.

Enclosures: 

Type 3R indoor/outdoor lockable metal enclosure

Knockouts: 

Combination of 12 1/2 - 3/4 inch size

Wire Size:

 AWG #18-#8

BACnet

®

 is a registered trademark of ASHRAE.

Metasys

® 

is a registered trademark of Johnson Controls, Inc.

Содержание ET9500







Отзывы: