7
OPT
KEYPAD FEATURES
1
NOT USED
2
SILENT KEYPAD? Enable Silent Keypad Option. If enabled, only the entry/exit
and sounder chime are silenced.
3
DING DONG CHIME? Enable Ding Dong Sound for Chime. If off, chime will be
a single tone. (Refer to NX8-E Installation manual, location 40)
4
5 SEC. SILENCE? Enable Keypress Silence Option. Silences the pulsing
keypad sounder for 5 seconds when a key is pressed.
5
ARMED ZONE INFO? Enable Armed Zone Information. If on, the LCD keypad
will display faulted or bypassed zone information when the system is armed.
6
BEEP ON PANICS? Enable Panic, Fire, and Medical Beeptone. Will sound a
short beep to verify that the keypress was accepted.
7
DISABLE SERVICE? Suppresses the "Service" Message. This will not allow the
"Service Required" message to be displayed for any reason. If there is a system
trouble, [
7
]-[2] will still show the "Service Required" menu.
8
MASTER KEYPAD? Enable Multi-partition Mode
9
CUSTOM MESSAGE? Enable Custom Message Display
10
CLOCK? Enable Clock Display
11
CUSTOM MSG. LOCK? Enable Custom Message Lock. Prevents over-writing
the custom message during keypad copy.
12
SELECT AN OPTION: Programs special characteristics.
1=Display “Press
7
For Help”
2=Disable LED Extinguish on this keypad
3=On if PIN should be hidden when
programming
4=On suppresses beeps when an
RF transmission is lost
5-8=RESERVED (Do not
program!)
U
U
9 4
SET KEYPAD NUMBER AND PARTITION
1) Enter [
U
]-[9]-[4]
The LCD screen will prompt “Please Enter Your
Code”.
2) Enter [program code]
The LCD will now prompt you for the keypad
number followed by [
7
]. The current keypad
number will be displayed in the lower right hand
corner.
3) Enter the keypad number
followed by [
7
]
The LCD will now prompt you for the partition
number followed by [
U
]. The current partition will
be displayed in the lower right hand corner.
4) Enter the partition number for
the keypad
The keypad will automatically exit this mode now.
KEYPAD FUNCTIONS
U
U
9 0
READING THE EVENT LOG
The control panel has an event log that can be retrieved using a master code. This log
contains a listing of the last 185 events along with date, time, and partition where the event
occurred.
1) Press [
U
]-[9]-[0]
The LCD screen will prompt you for a code.
2) Enter [master code]
The LCD screen will now show the most recent
event.
3) To view the events from most recent to the oldest, press the down scroll key.
4) To view the events from the oldest to the newest, press the up scroll key. The display
