8
NX-148E-RF LCD Touchpad w ith Receiver Installation Instructions
Table 7. Editing character data
Com mand
Action
*
Saves character or w ord. Moves cursor to the right.
CANCEL
Moves cursor to the left.
Scrolls through available characters. In library mode,
scrolls through available w ords.
STAY
Inserts a black space.
CHIME
Deletes characters.
EXIT
Accesses the library page.
BYPASS
Makes the character flash. If you are in library mode, it
w ill make the entire w ord flash.
#
Exits.
Set touchpad options (93)
To set touchpad options, do the following:
1. Press * 93.
2. Enter your program code.
3. Follow the instructions on the bottom line of the display to
select the options you want (see
Table 8
). If you do not
want to change an option, press * to advance to the next
option.
4. To exit, press #
Table 8. Touchpad options
Option
Touchpad features
1
Not used
2
Silent touchpad - Enables silent touchpad option. If
enabled, only the entry/exit and sounder chime are
silenced.
3
Ding dong chime - Enable the ding dong sound for chime.
4
5 second silence - Silences the pulsing touchpad sounder
for 5 seconds w hen a key is pressed.
5
Armed zone info - Touchpad w ill display faulted or
bypassed zone information w hen the system is armed.
6
Beeps on panics - Will sound a short beep w hen the
keypress is accepted.
7
Disable service - Suppresses the
Service
message.
8
Master touchpad - Enables multi-partition mode.
9
Custom message - Enables custom message display.
10
Clock - Enables clock display.
11
Custom message lock - Prevents over-w riting the custom
message during touchpad copy.
12
Select an option - Programs special characteristics.
1 = Display
Press * For Help
2 = Disable LED extinguish on this touchpad
3 = On if PIN should be hidden w hen programming
4 = On suppresses beeps w hen an RF Transmission is
lost.
5-8 = Reserved (do not program)
Set elapsed time since the last autotest (95)
To set the elapsed time (in minutes) since the last autotest, do
the following:
1. Enter * 95.
2. Enter your program code.
3. Enter the elapsed time in minutes using three digits. For
example, enter 005 for 5 minutes.
4. To exit, press #.
Set system time and date (97)
To set the system time and date, do the following:
1. Enter * 97.
2. Enter your program code.
3. Press or to scroll for the proper hour.
4. Press * to advance to the next selection (minutes).
5. Repeat steps 3 and 4 until the time and date are set.
6. To exit, press #.
Call back for download (98)
To cause the control to do a call back for download (while the
system is disarmed), enter * 98.
Seize phone line for download (99)
To cause the control to seize the phone line for a download
(while the system is disarmed), enter * 99.
Walk test (CHIME)
The walk test allows you to walk through to test the zones
(while the system is disarmed). To do a walk test, do the
following:
1. Enter * CHIME.
2. Enter your user code.
3. Walk through the zones. Each time a zone is faulted, it will
be displayed on the touchpad and a chime will sound.
4. The walk test mode will exit after 15 minutes, or you can
enter your user code to exit at anytime.
