Intergraph ImageStation ZII and use, Инструкция по установке и эксплуатации

Страница: 10 / 22

6
NOTE Ensure that the cables extend to the back of the interface PEM. Verify that the front feet of the
interface PEM install into the holes provided in the PEM bracket. These holes provide a positive lock-
down to prevent unwanted movement of the interface PEM.
5. The Altek digitizer controller is pre-mounted on the underside of the table as shown in the
following figure. Connect the 15-pin to 9-pin Analog to Digital converter to the port labeled
Cursor on the Altek digitizer controller. Connect the other end of the RS-232 cable from Tablet
of the Interface PEM (which you connected in step 3), to the 15-pin to 9-pin Analog to Digital
converter. Tighten the cable screws.
15-pin to 9-pin
Analog to Digital
Converter
AC Power Cord
Receptacle
To Two-Handed Controller
To COM 1
To AC
Adapter
Altek Digitizer
Controller
Interface PEM
From Tablet of
Interface PEM
To COM 2
6. Connect one end of an RS-232 cable to the port labeled RS-232 on the Altek digitizer controller.
Connect the other end of the cable to COM 1 port on the TDZ workstation base unit. Tighten the
cable screws.
7. Connect the round DIN end of the cable from the AC adapter to the power cord receptacle on the
Altek digitizer controller.
8. Connect the interface PEM power cord to the AC power cord receptacle on the back of the
interface PEM.
Install the Stereoscopic Display Subsystem
The stereoscopic display subsystem lets you view three-dimensional computer generated images. It
consists of an infrared transmitter, a cable assembly, and stereoscopic glasses.
To install the stereoscopic display subsystem:
1. Place the infrared transmitter on top of the monitor and face the infrared disperser panel towards
the user. No special mounting is required.
2. Set the infrared transmitter switch to the High position.