Intergraph ImageStation ZII and use, Инструкция по установке и эксплуатации

Страница: 7 / 22

3
3 Installing the Hardware
You will set up the components of the ImageStation ZII hardware in the following order:
1. Cyborg chair
2. Monitor table
3. D-sized digitizer table with Altek digitizer controller
4. TDZ workstation base unit and keyboard
5. Monitor
6. Interface peripheral equipment module (PEM), two-handed controller, and cabling
7. Stereoscopic display subsystem
To connect the power cords and set the switches, refer to Chapter 4. Chapter 6 includes instructions
to install and customize the Altek driver.
Equipment Cautions
WARNING Do not sit or lean on the digitizer tabl e during or after assembly. Failure to heed this warning
may result in equipment damage.
Note the following cautions when installing and using ImageStation ZII hardware:
u
The digitizer table work surface is a non-load bearing surface. Damage to sensitive parts may
occur if used for purposes other than intended.
u
The stereoscopic glasses are fragile. Handle them carefully. When not in use, store the glasses
in the box they came in or another suitable container.
u
Do not immerse the stereoscopic glasses in water or other liquids. Consult the documentation
delivered with the glasses for more information on the care and cleaning of the glasses.
Assemble the Cyborg Chair
To assemble the Cyborg chair:
1. Remove the installation and assembly instructions from the packing box and review them.
2. Remove the Chair Base/Casters assembly from the packing box and place it on the floor with the
casters down.
3. Remove the Chair Seat/Arms assembly from the packing box.
4. Insert the Chair Seat/Arms assembly post into the center hole of the Chair Base/Casters
assembly. Apply firm, even pressure to seat the post into the Base/Caster assembly.
Assemble the Monitor Table
Remove the monitor table from the packing box. Refer to the documentation delivered with the KI
workstation furniture for detailed instructions for assembling the monitor table.