Intergraph ImageStation ZII and use, Инструкция по установке и эксплуатации

Страница: 20 / 22

16
Adjust the Digitizer Table
Adjust the height of the digitizer table so that your arms are comfortably at your side when using the
two-handed controller or keyboard.
Your elbows should be bent at approximately 90 degrees when your hands are resting on the two-
handed controller or at the keyboard. If the table is at the lowest setting, you may need to raise the
chair height to place your hands at a proper height. A footrest may be required if your feet do not rest
flat on the floor.
To adjust the digitizer table:
1. Move the digitizer table out from under the monitor table when using the entire digitizing area.
2. Lock the casters on the digitizer table when in use to prevent it from moving unintentionally.
Adjust the Monitor Table
The monitor table should be centered along the back edge of the digitizer table so that the monitor
screen will be directly in front of you.
Adjust the height of the monitor table so that the center of the monitor screen is slightly below eye
level.
Adjust the Monitor Position
The monitor should be placed on the monitor table. The monitor base should be centered on the table
top to evenly distribute the weight of the monitor on the table. This position allows enough room for
the placement of the keyboard in front of the monitor, if desired.
NOTE Avoid placing the monitor so that it ref lects glare from room lights.
Adjust the Keyboard Position
The keyboard can be placed in any position on the digitizer table, or on the front of the monitor table,
according to your preference.
To use the keyboard:
1. For periods of infrequent keyboard input, place the keyboard on the front edge of the monitor
table in front of the monitor.
2. For periods of frequent keyboard input, place the keyboard on the digitizer table in front of you.
NOTE When not in use, the keyboard can be moved to either side of the digitizer table.